Due to the different monitor and light effect, the actual color of the item might be slightly different from the color showed on the pictures. Thank you!
Please allow 1-3cm measuring deviation due to manual measurement.
The power wiring controller comes with a 20cm long 10AWG input wire. One end has been crimped with a U-shaped terminal, and the other end has not been processed.
Connect the crimped U-shaped terminal to the control power input terminal, and the other end is processed according to its own power supply. Do not connect the negative electrode wrong.
There is a power switch under the control board. After pressing, wait for 3 seconds. After the buzzer drops, the LCD lights up and the boot is complete. Press the power switch again to shut down.
Screen description and parameter adjustment. There are currently three parameters on the screen:
Using automatic touch welding mode, while retaining the manual trigger interface, you can choose according to your own use.
The power board uses 2 ounces copper to increase the overcurrent capacity.
using 5 300A MOS tubes, non-disassembled MOS tubes.
The MOS tube driver adopts the imported special chip driver. The fastest MOS tube can be hit with 20nS. The switch is fast to prevent the explosion of the tube and the non-triode push-pull drive.
The MOS drive design adds a transient diode to protect the MOS and prevent the explosion of the tube. 10AWG multi-filament flexible wire is used for the welding pen line and the input line to increase the overcurrent capacity.
The controller is mainly for welding nickel-plated steel strips from 0.1mm to 0.15mm.
A 25V10000uF high-frequency low-resistance capacitor is added to the power input for energy compensation, which increases welding stability.
WELD WAY: There are MANUALE and AUTO welding energy adjustment. You can directly adjust the welding mode selection by pressing the up and down keys, and switch by pressing the square key.
Welding Press the welding pen obliquely to the nickel strip to keep the welding needle clean. According to the actual test, if the welding needle is ground into a round head, the welding effect can be improved.
There are two ways of welding, manual and automatic. In manual mode, you can make a trigger switch by yourself. The plug of the control belt can be plugged into the manual trigger socket of the control. Each time the trigger switch is pressed, the buzzer will sound twice to complete a welding.
In the automatic mode, when the two welding pins touch the nickel strip, there is a delay of 1 second, and the buzzer emits three beeps to automatically complete one welding.
Including: 1 X controller, 1pair X soldering pens, including soldering pins, U-type cold-pressed terminals, the total length of the soldering pen is about 30cm/11.81in
1 X Red power input line, 1 X Blue power input line, 10AWG, 20cm/7.87in long, 1pair X U-shaped cold-pressed terminals (for input power supply), Thousands of heat shrinkable tubes, used to shrink the power input line Wide selection of welding power supply: lithium battery power supply or 12V car battery.
The controller is controlled by a single chip microcomputer, and the output pulse is accurate to ensure the welding quality.